Wheelchair Ramp, Overcomes Steps and Curbs (Depth 30 cm) | PEPE | P10040

Keep these measurements in mind to confirm that you can use the 60cm deep ramp where you want.

• The step height (measurement A) must be greater than or equal to 2 cm and less than 7 cm. If this is the case, you can install the 30 cm deep ramp without problems.

SAFE

 Non-slip surface and reflective strips on both sides.

NON-SLIP

The wheelchair ramp is designed with a non-slip surface . to prevent slips and falls when using wheelchairs, walkers, strollers or scooters.

EASY TO INSTALL AND TRANSPORT

The wheelchair ramp has a total depth of 30 cm and a total width of 81 cm . It is adjustable and very easy to remove and install. The ramp weighs 2.7 kg and supports up to 272 kg.

STEP 1

Determine the installation location and mark its position with a marker on the holes in the base. With the position clear and an 8 mm drill bit, Make the holes in the surface.

Insert the Ø8x40mm plugs in the holes and carefully use a hammer if necessary.

STEP 3

Set the screws of Ø4.9x38mm through the holes in the ramp. Make sure the ramp is secure.

IMPORTANT: If the surface is plastic or wood, two additional screws of Ø4x17mm are included.