Wheelchair Ramp (for Door Profiles ≤ 6 mm Height) | KMINA | K10064

DESIGNED FOR DOOR THRESHOLDS

The design of the bridge threshold ramp features a rear slot to fit into the threshold transition profile from the door.

Allows save profiles up to 6 mm high , providing support and security.

ADJUSTABLE

The wheelchair ramp is adaptable thanks to its cutting slots . It adapts to different door sizes and can be reduced to 60 cm, with a maximum of 90 cm. It's very easy to remove and replace.

IMPORTANT : Strength and a wide, large-bladed utility knife are required to make the necessary cuts.

NON-SLIP

The door ramp is designed with a non-slip texture throughout to prevent slips and falls when using wheelchairs, walkers, or strollers.

STEP 1: Measure the width of the door

Take the ramp out of the box and spread it so that it is even since it comes rolled up. The surface where it is to be placed must be regular and not have a large slope .

With the help of a meter measure the width between the door frames where you want to place the wheelchair ramp.

Use a wide, large-bladed utility knife to cut off the excess ramp in several passes.

IMPORTANT : It is necessary use force in the process

STEP 3: Separate both sides

Fold the chosen slot several times to make the process easier until you manage to separate both sides.

RECOMMENDATION : You can use the excess ramp as a door wedge.

READY!

Place the ramp on the door threshold transition profile so you can pass your wheelchair, walker, or even your shopping cart.

IMPORTANT : The rear slot must be firmly attached to the door threshold so that the ramp does not slide.